Scan-Electronics RadiaCode-101

To Next Page

To Previous Page

Standalone usage 21

To return to the top level or quit the menu, set

focus on the [<Back] or [<< Menu quit] item

respectively and confirm your choice by short

pressing the round button.

3.8.2 Measurement units

Use [Measurement units] item of Settings submenu to change the units of Monitor, Dose and Search

display modes:

while in the Settings, set focus on the [Measurement units] by short

pressing the "up" and "down" swing buttons;

enter the submenu by short pressing the round button.

If you need to change the units of Monitor / dose rate and Dose display modes take the following steps

(while in the [Measurement units]):

set focus on the [Dose] item by short pressing

the swing buttons;

select the dose (and dose rate) units by short

pressing the round button: Sv {Sievert} (Sv/h

for Monitor mode) or R {Roentgen} (R/h for

Monitor mode).

If you need to change the units of Monitor / count rate and Search display modes take the following

steps (while in the [Measurement units]):

set focus on the [Count rate] item by short

pressing the swing buttons;

select the count rate units by short pressing

the round button: CPS {counts per second} or

CPM {counts per minute}.

To return to the Settings or quit the menu select [<Back] or [<< Menu quit] item respectively and

confirm your choice by short pressing the round button.

Scan-Electronics RadiaCode-101 - Measurement Units