Scan-Electronics RadiaCode-101

To Next Page

To Previous Page

Standalone usage

3.8.3 Dose rate

Use [Dose rate] item of Settings to set up the alarm thresholds 1 and 2 for the dose rate estimation:

while in the Settings,set focus on the [Dose rate] item by short pressing

the "up" and "down" swing buttons;

enter the submenu by short pressing the round button

If you need to change the alarm threshold 1, take the following steps (while in the [Dose rate] submenu):

set focus on [Alarm 1] item by short pressing

the swing buttons;

enter the submenu by short pressing the round

button, then setup dialog will appear;

select the desired digit of the threshold value

by short pressing the round button;

change the value of the selected digit by short

pressing the swing buttons;

repeat the previous two steps to set all digits of

the value.

To return to the higher level with or without

changes select [Enter] or [Esc] item

respectively;

confirm your choice by long pressing the round

button.

If you need to change the alarm threshold 2, take the following steps (while in the [Dose rate] submenu):

set focus on [Alarm 2] item by short pressing