2 © Scania CV 2009
Foreword
This Operator’s Manual describes the handling and maintenance of Scania
DC12 and DI12 Industrial Engines with EMS S6/PDE injection systems.
The engines are of direct-injection, liquid-cooled, four-stroke, 6-cylinder in-
line diesel type. These engines have turbochargers and charge air coolers; see
page 14.
Common applications are as power units in construction machines, generator
sets, earth-moving, railway and forestry machines as well as in irrigation
systems.
The engines can have different output and speed settings.
The normal output setting of the engine (performance code) is indicated on
the type plate, see page 14.
Note: Only standard components are described in the Operator’s
Manual. Please see the manufacturer’s instructions regarding
special equipment.
In order to obtain the best value and service life from your engine, there are
several points you should bear in mind:
- Read the manual before starting to use the engine. Even though you may
have experience of Scania engines you may find new information in this
Operator’s Manual.
- Follow the maintenance instructions. Good working order and service
life are ensured if maintenance is carried out according to the
instructions.
- In particular, read the safety information starting on page 6.
- Get to know your engine so that you know what it can do and how it
works.
- If necessary, contact an authorised Scania workshop. They have special
tools, genuine Scania parts and staff with training and practical
experience of Scania engines.
Note: Always use genuine Scania parts during service and repair so as
to keep your engine in the best possible working order.
The information in this manual was correct at the time of going to press.
However, we reserve the right to make alterations without prior notice.
During the warranty period,
only genuine Scania parts may
be used during service and
repair; otherwise the warranty
will be invalidated.
Important
!
To Next Page
Loading...
Need help?
General
