General system description 2 - 4
Doc.nr : Rc400-Manuale_v20_e.doc
Portable control unit with battery operation ( radio control or opto fibre cable ).
A battery is located in the control unit for radio control and is very simple to change.
· The battery's effective operation time is about 8 hours on one charge.
· When the battery is approaching time for charging, the control unit beeps three ( 3 ) times
as a warning and at the same time the LED starts to blink on the control unit.
· The battery must be used until the LED goes out, after which it can be changed.
If the battery capacity is too LOW the control unit cannot be activated.
· The battery capacity and operational performance is reduced in extremely cold conditions.
( The battery is automatically charged during operation by cable control ).
· In order to reduce battery loading and for safety reasons, the control unit is turned off
automatically, after the unit has been idle for more than approximately five ( 5 ) minutes.
To Next Page
Loading...
Need help?
General
