30 Configuring the VEGA
6.1 PREFACE
How to configure the VEGA:
The Barcode Programming Feature gives the possibility to change the VEGA
scanner settings with use programming codes or with the Utility Tool.
6.1.1 Changing Scanner Settings with programming codes
You can set-up your VEGA by scan all necessary programming codes for
parameters that meet applications. After these scans the VEGA is direct
permanently saved. To go back to the factory default settings, just scan only
programming code factory default.
In order to change the scanner settings please follow the sequence below:
1. Power-up the scanner.
2. Change scanner settings by scanning any of the programming code that
meet applications.
An Example:
For changing the Baudrate to 38400 only scan the programming code that
represents this.
After reading a valid programming code the scanner will give a double High beep
and the green led indicator will lights on.
At any moment you can stop your programming, and if needed read programming
code factory default setting for set your scanner back to default.
To Next Page
Loading...
