Scantech-ID VEGA Area Imager
7.4 BLUETOOTH SCANNER SETUP
7.4.1
Preface
How to configure the Bluetooth function:
The Barcode programming feature gives the possibility to change the
scanner settings with use programming labels.
7.4.2
Changing Scanner Settings with programming
codes
You can set-up Bluetooth function by direct
scan all necessary programming
codes for Bluetooth parameters.
After reading a valid programming code the scanner will give a High
the Blue-Red led indicator will lights on.
By scanning “Set All Default” label, the settings will go back to the factory default
settings.
7.4.3
Bluetooth Default Setting
Default Setting
39
The Barcode programming feature gives the possibility to change the
VEGA
Changing Scanner Settings with programming
scan all necessary programming
After reading a valid programming code the scanner will give a High
-low beep and
By scanning “Set All Default” label, the settings will go back to the factory default
To Next Page
Loading...
