50 Programming Codes
Note: This step does not include codes for all support Bar code symbologies.
For a complete overview of support symbologies see appendix.
If you need programming codes for symbologies which are not available in this
chapter, please contact Scantech-ID Technical Support department or use
VEGA utility tool.
7.6.2 Disable all Symbologies.
Disable all Symbologies
- Disabled all Symbologies.
- Use the “OFF” option to disable individual symbologies.
- Does not reset individual parameters settings for each symbology.
(When you enable
a symbology, you recover the parameter settings stored in
memory for that symbology when it was disabled – use reset factory defaults to
reset all the symbology parameters to their factory default settings).
To Next Page
Loading...
