Scantech-ID VEGA Area Imager 73
7.17.2 Scanning Triggering
<Level>
A reading session begins (lighting and decode processing on) when
beam is activated and stops when beam is deactivated.
Continuous scanning
When the scanner is turned on a continuous reading session begins
(lighting and decode processing on).
Pulse
A reading session begins when beam is activated and stays
on until a period of inactivity lasting the time specified by the timeout.
After the timeout, the scan engine turns off.
Continuous + Flashing
When the scan engine is turned on, a reading session begins (no
need to activate the beam).
After a period of inactivity lasting the time specified by the timeout,
the scan engine starts flashing, checking for a bar code to be read.
When a bar code is detected, the lighting automatically turns on and
stays on until another period of inactivity (timeout).
After the timeout the scan engine starts flashing again.
To Next Page
Loading...
