www.schaerer.comOperation
Operating instructions / V07 / 06.2010
47 / 68
Operating modes
The Siena 1 / 2 has two (2) operating modes:
The machine is switched off but still connected to the power supply.
The following message appears on the display (shown left).
The machine is ready to operate.
The following message appears on the display (shown left).
Preparing products
If the „water low“ function indicator blinks during product dispensing, top up with water and re-insert
the tank.
Preparing coffee / espresso (whole-bean coffee)
The following instructions assume that the machine is ready to operate.
► Place a cup under the outlet (adapt the size to the product).
► Touch the desired product button. The product is dispensed.
► Wait until „Ready“ appears on the display. Remove the cup from under the outlet.
For a double product (2 cups), press the
button before pressing the product button.
Preparing DECAF coffee (coffee powder)
Do not use any water-soluble, freeze-dried or similar products. Use only pure, ground coffee. Fill
no more than 1-2 (level) measuring spoons into the coffee hopper.
► Press the
button. The indicator lights up.
► Place a cup under the outlet. The indicator ashes.
► Touch the desired product button. „Coffee powder“ appears on the display.
► Remove the lid from the hopper and add coffee powder. Press the
button. The product is dis-
pensed.
► Remove the cup from under the outlet.
If no additional product button is pressed within ± 2 minutes after the
button is pressed, the red
indicator for coffee powder goes out.
For a double product (2 cups), press the
button before pressing the button.
Preparing hot water (Siena 1)
The temperature indicator lights up in green.
► Place a cup under the hot water outlet.
► Turn the rotary dial (on the right-hand side) to the [ Hot water ] position.
► To cancel the dispensing procedure, turn the rotary dial back to its starting position (centre).
► Remove the cup from under the outlet.
<< Stand by >>
Ready
To Next Page
Loading...
Need help?
General
