www.schaerer.com Programming
50 / 68
Operating instructions / V07 / 06.2010
Programming
Your coffee machine is pre-programmed at the factory. You also have the option, however, of adjusting the
device to your individual tastes. You can program the following product-related elements (refer also to the
programming overview):
Water volume - coffee quantity - pre-brew function
In addition, you can program various device functions individually.
► If no entry is made during programming, the device automatically switches to the next menu after 30
seconds and/or switches to “Ready“ mode.
► The device can only be programmed in forward-moving steps.
► Programming in the
level can only be carried out with a PIN code.
The following instructions assume that the machine is ready to operate.
Navigation through the programming level
= Access to programming level / Conrm parameters; proceed to the next step
= Product settings
= General settings
= System settings
= increase or decrease values./ Block or release parameters
Button
[ 1 ]
button
[ 2 ]
Buttone
[ 3 ]
Button
[ 4 ]
1 4
*Illustration: Standard configuration,
Siena 2
Counter functions in standby mode
Switch the machine into standby mode by pressing the button. Afterwards, you can press the vari-
ous buttons to show the respective counter status.
= Total drinks dispensed by machine (all products)
= Double products dispensed
= DECAF drinks dispensed (ground coffee)
= Product counter per product button
= Cleaning counter
= Hot water dispensed
1 4
The factory settings are shown in bold
on the display!
To Next Page
Loading...
