Schaerer Siena 2 - Programming; Programming Navigation

www.schaerer.com Programming
54 / 68
Operating instructions / V07 / 06.2010
Overview: programming xed parameters
Accessing the programming level:
Ready
► Press to access the programming level..
Product, 2x, C
Press the button
Code ####
► Set each digit using or .
► Conrm by pressing
.
Counter status?
► Set counter level to 0 using (if desired).
► Conrm by pressing
.
Lock button
► Block individual buttons from use by pressing or .
► Conrm by pressing
.
Descaling ON
► Grant authorisation to descaling using or .
► Conrm by pressing
.
Prod. prog. ON
► Grant authorisation for product programming using or .
► Conrm by pressing
.
Sys. prog. ON
► Grant authorisation for system programming using or .
► Conrm by pressing
.
Counter ON
► Switch the counter display of the product buttons on or off using or .
► Conrm by pressing
.
16 ° - 20 ° dH
► Set water hardness using or .
► Conrm by pressing
.
With coin tester option only:
Change price
► Set the product button price using or .
► Conrm by pressing
.
With coin tester option only:
Acc. syst. OFF
► Switch accounting on or off using or .
► Conrm by pressing
.
Change code
► Set the authorisation code (each digit) using or .
► Conrm by pressing
.
Factory set.
► The machine can be reset to factory settings by pressing .
► Conrm by pressing
cancel by pressing .
Base cong.
► The parameters can only be changed by a qualied service technician (protected by PIN code)!
► Conrm by pressing
.
Ready
End of xed parameter programming.