Measurements and Recording P746/EN MR/A11
MiCOM P746 (MR) 8-
17
MR
Menu Text Default Settings Available settings
MEASUREMENT SETUP
Measurement ref VA
IA1 / IB1 / IC1 / VA / VB / VC /
IA2 / IB2 / IC2 / IA3 / IB3 / IC3 /
IA4 / IB4 / IC4 / IA5 / IB5 / IC5 /
IA6 / IB6 / IC6
This menu sets the reference of the measure (phase reference and angle)
Measurement Mode 0 0 / 1 / 2 / 3
Used to set the mode of measurement, according to the following diagram:
1.4.5 Measurement display quantities
There are “Measurement” columns available in the relay for viewing of measurement
quantities. These can also be viewed with MiCOM S1 and are shown below:
MEASUREMENTS 1
One box configuration Three box configuration
MEASUREMENTS 2
IA-1 Magnitude IX-1 Magnitude IA Z1 Diff
IA-1 Phase Angle IX-1 Phase Angle IB Z1 Diff
IB-1 Magnitude IX-2 Magnitude IC Z1 Diff
IB-1 Phase Angle IX-2 Phase Angle IA Z1 Bias
IC-1 Magnitude IX-3 Magnitude IB Z1 Bias
IC-1 Phase Angle IX-3 Phase Angle IC Z1 Bias
IA-2 Magnitude IX-4 Magnitude
IA-2 Phase Angle IX-4 Phase Angle
IB-2 Magnitude IX-5 Magnitude
IB-2 Phase Angle IX-5 Phase Angle IA Z2 Diff
IC-2 Magnitude IX-6 Magnitude IB Z2 Diff
IC-2 Phase Angle IX-6 Phase Angle IC Z2 Diff
IA-3 Magnitude IX-7 Magnitude IA Z2 Bias
IA-3 Phase Angle IX-7 Phase Angle IB Z2 Bias
IB-3 Magnitude IX-8 Magnitude IC Z2 Bias
IB-3 Phase Angle IX-8 Phase Angle IA CZ Diff
IC-3 Magnitude IX-9 Magnitude IB CZ Diff
IC-3 Phase Angle IX-9 Phase Angle IC CZ Diff
IA-4 Magnitude IX-10 Magnitude IA CZ Bias
IA-4 Phase Angle IX-10 Phase Angle IB CZ Bias
IB-4 Magnitude IX-11 Magnitude IC CZ Bias
IB-4 Phase Angle IX-11 Phase Angle
IC-4 Magnitude IX-12 Magnitude
IC-4 Phase Angle IX-12 Phase Angle
IA-5 Magnitude IX-13 Magnitude
IA-5 Phase Angle IX-13 Phase Angle
IB-5 Magnitude IX-14 Magnitude
IB-5 Phase Angle IX-14 Phase Angle
IC-5 Magnitude IX-15 Magnitude
IC-5 Phase Angle IX-15 Phase Angle
IA-6 Magnitude IX-16 Magnitude
IA-6 Phase Angle IX-16 Phase Angle
To Next Page