THE PRESENT MANUAL BELONGS TO - Schenker Italia - ALL RIGHTS RESERVED
34
This is a blinking messages that must be acknowledged pressing the key STOP
This messages suggest to replace both 5 and 20 microns filters.
DISPLAY INDICATIONS DURING PRODUCTION
During the normal functioning of the watermaker the display gives the following indications:
Pump 1 OFF/ON
Pump 2 OFF/ON
S = wait This means that the salinity meter is still completing calculations.
S = OK Quality of the produced water good (micro Siemens 0-1500)
S = MED Quality of the produced water medium (micro Siemens 1500-2000)
S = BAD Quality of the produced water bad (micro Siemens over 2000).
In this last case, please stop the watermaker and schedule a service.
TIME It is the time from the starting. If the timer function has been used the time will indicate the remaining
time to stop.
To Next Page
Loading...
Need help?
General
