Scheppach HBS30 Translation From The Original Instruction Manual

32 GB
15. Troubleshooting
Fault Possible cause Remedy
Motor does not work Motor, cable or plug defective, fuses burnt
Housing cover open (limit switch)
Arrange for inspection of the machine by a
specialist. Never repair the motor yourself.
Danger!
Check fuses and replace as necessary
Close housing cover exactly
The motor starts up
slowly and does not
reach operating
speed.
Voltage too low, coils damaged, capacitor
burnt
Contact the utility provider to check the voltage.
Arrange for inspection of the motor by a special-
ist.
Arrange for replacement of the capacitor by a
specialist
Motor makes exces-
sive noise
Coils damaged, motor defective Arrange for inspection of the motor by a special-
ist
The motor does not
reach its full power.
Circuits in the network are overloaded
(lamps other motors, etc.)
Do not use any other equipment or motors on
the same circuit
Motor overheats eas-
ily.
Overloading of the motor, insufcient cool-
ing of the motor
Avoid overloading the motor while cutting,
remove dust from the motor in order to ensure
optimal cooling of the motor
Saw cut is rough or
wavy
Saw blade dull, tooth shape not appropriate
for the material thickness
Resharpen saw blade and/or use suitable saw
blade
Workpiece pulls away
and/or splinters
Excessive cutting pressure and/or saw
blade not suitable for use
Insert suitable saw blade
Saw blade is not run-
ning straight
a) Guide has been wrongly set
b) Wrong saw blade
a) Set the saw blade guide according to the
operating instructions
b) Select a saw blade according to the operating
instructions
Burn marks appear on
the wood during the
cutting work
a) Blunt saw blade
b) Wrong saw blade
a) Change the saw blade
b) Select a saw blade according to the operating
instructions
Saw blade jams during
cutting work
a) Blunt saw blade
b) Deposits on the saw blade
c) Guide has been set poorly
a) Change the saw blade
b) Clean the saw blade
c) Set the saw blade guide according to the
operating instructions

Scheppach HBS30 Specifications

General

Product type	Vertical band saw
Product color	Blue, Grey
Built-in light	-
Adjustable speed	Yes
Housing material	Steel, Aluminium
Table bevel angle	0 - 45 °
Input power	350 W
Power source	AC
AC input voltage	230 - 240 V
AC input frequency	50 Hz
Cutting width	- mm
Cutting height @ 90°	80 mm
Number of teeth per inch (TPI)	6, 10, 15

Weight and Dimensions

Depth	730 mm
Width	420 mm
Height	540 mm
Weight	20500 g
Table depth	520 mm
Table width	300 mm