Scheppach HM254SPX

 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
GB
|
29
The above-mentioned noise emission values were
measured in accordance with a standardised test pro-
cedure and can be used to compare one power tool
with another.
The above-mentioned noise emission values can also

Warning:
• The noise emissions during the actual use of the
   󰀨   
values depending on the power tool being used, in

•    -


consideration (such as the times when the tool is
󰀨
7. Before starting the equipment
• Open the packaging and remove the device care-

• Remove the packaging material as well as the pack-
aging and transport bracing (if available).
• 
• 
damage.
•   
period has expired.
ATTENTION
The device and packaging materials are not toys!
Children must not be allowed to play with plastic
bags, lm and small parts! There is a risk of swal-
lowing and su󰀨ocation!
• The equipment must be set up where it can stand
      
base frame or similar. Insert 4 screws (not included

saw table (15). Tighten up the screws.
• Loosen the tilt protection (36) pre-installed at the


• Adjust the adjusting screw (38) to the level of the
tabletop to avoid wobbling of the machine.
• 

• 
• When working with wood that has been processed
before, watch out for foreign bodies such as nails or
screws, etc.
• 


• 
the machine is in operation.
• 󰀨-

Warning!

-
sive medical implants under certain conditions. In or-
    
we recommend that persons with medical implants

the medical implant prior to operating the electric tool.
6. Technical data
AC motor ..................................... 220 - 240 V
~
50 Hz
Power S1 .................................................... 1800 Watt
Operating mode ............................... S6 25%* 2200 W
Idle speed n
0
............................................... 4800 min
-1
Carbide saw blade ...................ø 254 x ø 30 x 2,8 mm
Number of teeth .......................................................48
Maximum tooth width of saw blade ....................3 mm
Swivel range ........................................ -45° / 0°/ +45°
Mitre cut .........................................0° to 45° to the left
Saw width at 90° ..................................... 340 x 90 mm
Saw width at 45° ..................................... 240 x 90 mm
Saw width at 2 x 45°
(double mitre cut)) ..................................240 x 46 mm
Protection class ..................................................II /
Weight .......................................................ca. 14,4 kg
Laser class ................................................................2
Wavelength of laser .........................................650 nm
Laser output....................................................< 1 mW
      
-

25% of the running time.
The work piece must have a minimum height of 3
mm and a minimum width of 10 mm.
Make sure that the workpiece is always secured
with the clamping device.
Noise
Total noise values determined in accordance with EN
62841.
Sound pressure level L
pA
........................... 96,5 dB(A)

pA
.................................................... 3 dB
Sound power level L
WA
............................. 109,5 dB(A)

WA
.................................................... 3 dB
Wear hearing protection.
󰀨