Scheppach HM254SPX - Troubleshooting

 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
GB
|
35
15. Troubleshooting
Fault Possible cause Remedy
Motor does not work Motor, cable or plug defective, fuses burnt 
specialist.


The motor starts up

reach operating speed.
Voltage too low, coils damaged, capacitor
burnt
Have an electrician check the voltage.
-

specialist
Motor makes exces-
sive noise
Coils damaged, motor defective -
ist
The engine does not
reach full power.
Circuits in the network are overloaded
(lamps, other motors, etc.)

same circuit
Motor overheats

󰀩-
ing of the motor
Avoid overloading the motor while cutting,
remove dust from the motor in order to ensure
optimal cooling of the motor
Saw cut is rough or

Saw blade dull, tooth shape not appropriate
for the material thickness
Re-sharpen saw blade and/or use suitable saw
blade

and/or splinters
Excessive cutting pressure and/or saw
blade not suitable for use
Insert suitable saw blade