Scheppach HMS1070 Translation From The Original Instructions

31GB
• Folds caused by the improper attachment of run-
ning of the connecting leads.
• Cutsresulting from the crossing of the connect-
ing lead.
• Insulation damages caused by the ripping out of
the connecting lead from the wall socket.
• Cracks due to the ageing of the insulation.
Faulty electrical connecting leads such as these
may not be used and are highly dangerous due to
the insulation damage.
Check electrical connecting leads regularly for
damage. Ensure that the connecting lead is not at-
tached to the mains supply when you are checking
it.
Electrical connecting leads must correspond to the
relevant VDE and DIN regulations. Only use con-
necting leads with the code H05VV-F.
The type designation must be printed on the con-
necting lead by regulation.
AC motor
• The supply voltage must be 230 volt ~ / 60 Hz.
• Extension leads up to 25 m in length must have
a cross-section of 1.5 mm², > 25 m length / 2,5
mm².
Connections and repairs of electrical equipment
may only be performed by a qualied electrician.
Please give the following information if you have
any enquiries:
• Kind of current
• Machine type label data
• Data on the main label
13. Disposal and recycling
The equipment is supplied in packaging to prevent
it from being damaged in transit. The raw materi-
als in this packaging can be reused or recycled. The
equipment and its accessories are made of various
types of material, such as metal and plastic. Never
place defective equipment in your household refuse.
The equipment should be taken to a suitable collec-
tion center for proper disposal. If you do not know the
whereabouts of such a collection point, you should
ask in your local council of ces.
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical
and electronic equipment (WEEE). This product must
be disposed of at a designated collection point.
This can occur, for example, by handing it in at an
authorised collecting point for the recycling of waste
electrical and electronic equipment. Improper han-
dling of waste equipment may have negative conse-
quences for the environment and human health due
to potentially hazardous substances that are often
contained in electrical and electronic equipment.
By properly disposing of this product, you
are also contributing to the effective use of natu-
ral resources. You can obtain information on collec-
tion points for waste equipment from your municipal
administration, public waste disposal authority, an
authorised body for the disposal of waste electri-
cal and electronic equipment or your waste disposal
company.
14. Spare-part ordering
Please quote the following in your order for spare
parts:
• Type of device
• Article No. of deviceIdent. No. of device
• Spare Part No. of the required spare part
Service information
Please note that the following parts of this product
are subject to normal or natural wear and that the
following parts are therefore also required for use as
consumables.
Wear parts*: Planer blades, motor drive belt, carbon
brushes
* Not necessarily included in the scope of delivery!

Scheppach HMS1070 Specifications

General

Idle speed	8500 RPM
Product color	Black, Blue
AC input voltage	230 V
AC input frequency	50 Hz
Soleplate material	Aluminum
Dust extraction port	Yes
Planning width (max)	252 mm
Input power	1500 W
Power source	AC
Number of blades	2
Planing depth (max)	120 mm

Weight and Dimensions

Depth	1020 mm
Width	520 mm
Height	400 mm
Weight	30900 g