www.scheppach.com
34
|
GB
17. Wear suitable personal protective equipment,
such as:
– hearing protection;
– protective gloves when handling saw blades.
18. -
ufacturer which conform to EN 847-1. Warning!
When changing the saw blade, make sure that the
cutting width is not smaller and the thickness of
the saw blade is not greater than the thickness of
the splitter.
19. When sawing wood and plastics, avoid overheat-
ing the saw teeth. Reduce the feed speed to avoid
the plastic melting.
Residual risks
The machine has been built according to the state
of the art and the recognised technical safety re-
quirements. However, individual residual risks can
arise during operation.
Health hazard due to electrical power, with the use of
improper electrical connection cables.
• Furthermore, despite all precautions having been
-
main.
• -
structions“ and the „Proper use“ are observed along
with the whole of the operating instructions.
•
blade, which results in reduced output of the ma-
chine in the processing and in cut precision.
• Avoid accidental starting of the machine: the oper-
plug in an outlet.
• Use the tool that is recommended in this manual. In
•
the machine is in operation. Release the handle
-
erations.
disconnect the mains power plug!
j) Make sure that the saw blade is mounted in the
correct direction of rotation. Do not use grind-
ing discs or wire brushes with the circular ta-
ble saw.
the use of accessories that have not been recom-
Safety instructions for the handling of saw blades
1.
their use.
2. Observe the maximum speed. The maximum
3. Observe the motor / saw blade direction of ro-
tation.
4.
cracked insertion tools. Repairs are not permitted.
5.
surfaces.
6.
the reducing of holes on saw blades.
7.
insertion tool have the same diameter and have at
least 1/3 of the cutting diameter.
8.
each other.
9.
-
ers. Wear protective gloves in order to improve
10. Prior to the use of insertion tools, make sure that
11. Prior to use, make sure that the insertion tool
meets the technical requirements of this electric
12. -
ations in wood, materials similar to wood, plastics
and non-ferrous metals (except for magnesium
13. Use the saw blade intended for the material to be
processed.
14.
15.
or higher rotational speed than that marked on the
power tool.
16. -
facturer which conform to EN 847-1, if intended for
cutting wood or similar materials.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
