www.scheppach.com
40
|
GB
Please provide the following information in the event
•
•
•
15. Disposal and recycling
The equipment is supplied in packaging to
prevent it from being damaged in transit.
This packaging is raw material and can thus
be used again or can be reintegrated into
such as metals and plastics. Take defective
components to special waste disposal sites. Check
Old devices must not be disposed of with house-
hold waste!
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and
electronic equipment (WEEE). This product must be
disposed of at a designated collection point. This can
electronic equipment. Improper handling of waste
-
ardous substances that are often contained in electri-
use of natural resources. You can obtain information on
-
• -
-
-
ments.
Important information
In the event of an overloading the motor will switch
motor can be switched back on again.
Damaged electrical connection cable
The insulation on electrical connection cables is of-
ten damaged.
• Passage points, where connection cables are
passed through windows or doors.
• Kinks where the connection cable has been improp-
• Places where the connection cables have been cut
due to being driven over.
• Insulation damage due to being ripped out of the wall
outlet.
• Cracks due to the insulation ageing.
Such damaged electrical connection cables must not
be used and are life-threatening due to the insulation
damage.
Check the electrical connection cables for damage
not hang on the power network during the inspection.
-
cables with the marking „H05VV-F“.
AC motor
• The mains voltage must be 230 V~
• Extension cables up to 25 m long must have a
cross-section of 1.5 mm
2
.
Connection type Y
If the mains connection cable of this device is dam-
avoid dangers.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
