www.scheppach.com
GB
|
37
9.4.2 Turning the stop rail (gs. 15 - 16)
-
rail (27).
- Now, the stop rail (27) can be removed from the
guide rail (29) and pushed over it again using the
corresponding guide.
- Tighten the wing nuts (28) again.
- The stop rail (27) can be applied to the left or right of
the bolts from the other side of the guide rail (29).
9.4.3 Setting the cutting width (g. 17)
- The rip fence (15) must be used for longitudinal cut-
ting of wood parts.
- The rip fence (15) should be mounted on the right
side of the saw blade (3).
- Set the rip fence (15) on top of the guide rail for rip
fence (14).
- On the guide rail for rip fence (14), there are 2 scales
which indicate the distance between the rip fence
(15) and the saw blade (3).
- Select the appropriate scale depending on whether
the stop rail (27) is rotated for processing thick or
thin material:
High stop rail (thick material):
Low stop rail (thin material):
- Set the rip fence (15) to the desired level in the sight
fence (30).
-
that the rip fence is aligned parallel to the saw blade.
9.5 Transverse stop (g. 18)
- Push the transverse stop (7) into a groove (31a/31b)
of the saw bench.
- Loosen the handle screw (32).
- Turn the cross stop (7) until the desired angle is set.
The arrow on the transverse stop is at the set angle.
(0°-60°)
- Tighten the knurled screw (32) again.
- The stop rail (34) can be moved on the transverse
stop (7). Loosen the nuts (33) and push the stop rail
(34) to the desired position. Tighten the nuts (34)
again.
Caution!
- Do not push the stop rail (34) too far towards the
saw blade.
- The distance between the stop rail (34) and saw
blade (3) should be about 2 cm.
11.
then release it. The saw blade guard should auto-
9. Using the saw
9.1 On/O switch (g. 14)
-
pushbutton „I“. (11)
- The red pushbutton „0“ (11) has to be pressed to
9.2 Cutting depth (g. 14)
Turn the round handle (12) to set the blade (3) to the
required cutting depth.
- Anticlockwise: smaller cutting depth
- Clockwise: larger cutting depth
trial cut in order to check the set dimensions.
9.3 Setting the angle (g. 14)
left oriented to the stop bar from 0 ° to 45 °.
m Check before each cut, that between the stop bar
(27), cross-stop (7) and the saw blade (3) a collision
is not possible.
-
-
turning the hand wheel (12).
- -
gle position.
9.4 Working with the rip fence
9.4.1 Setting the stop height (gs. 15 - 16)
- The stop rail (27) of the rip fence (15) has two guide
- Depending on the thickness of the material to be cut,
thick material (about 25 mm workpiece thickness)
25 mm workpiece thickness).
To Next Page
Loading...
Need help?
General
Weight and Dimensions
