Scheppach HS100S - 13. Storage; 14. Electrical connection; 15. Disposal and recycling

www.scheppach.com
GB
|
41
16. Troubleshooting
Problem Possible cause Help
Saw blade gets
loose after turning
󰀨
Fixing nut not tight enough 
Motor does not start
Mains fuse blown Check the mains fuse
Extension cable defect Replace the extension cable
Connections to the motor or switch
not OK

Motor or switch defective 

power, fuse tripping
Cross section of the extension cable
󰀩
See “Electrical Connection” in the operating
manual
Overload due to blunt saw blade Replace saw blade
Burn areas at the
cutting surface
Blunt saw blade Sharpen saw blade, replace
Wrong saw blade Replace saw blade