Set up your lock.
1. Open your door!
2. Enter one of the two default user codes.
3. Your lock will enter a setup routine. When the bolt stops moving, setup is complete.
Final test!
1. Close your door.
2. Extend and retract the bolt using the inside thumbturn.
3. Make sure the bolt retracts smoothly.
4. Open your door.
5. Extend the bolt using the inside thumbturn.
6. Now enter a user code at the touchscreen.
Need Help?
If the bolt doesn’t extend or retract during testing,visit schlage.com/faqs-encode.
To Next Page
Loading...
