SCHÖLLY FIBEROPTIC LED Light Source

Questions and Answers

D
Daniel PattersonAug 10, 2025
Why SCHÖLLY FIBEROPTIC LED Light Source Medical Equipment has not enough light?
- A
  Alan JohnsonAug 10, 2025
  If your SCHÖLLY FIBEROPTIC Medical Equipment isn't providing enough light, consider these potential causes: 1. The light guide may not be connected correctly; ensure it is properly seated. 2. The light guide could be defective; consider replacing it. 3. The adapter might not be fully screwed on; tighten it completely. 4. The light guide may not be fully inserted; use a compatible light guide.
C
catherine66Aug 14, 2025
What to do if SCHÖLLY FIBEROPTIC LED Light Source has no operation?
- S
  Sharon LunaAug 14, 2025
  If your SCHÖLLY FIBEROPTIC Medical Equipment is not operating, check the following: * Ensure the power connection is secure and connected. * Check the fuse and replace it if necessary. If these steps don't resolve the issue, there may be a malfunction in the power supply unit, and the light source should be sent in for repair.
R
rtaylorAug 25, 2025
What to do if fans do not work in SCHÖLLY FIBEROPTIC LED Light Source?
- S
  Stephanie PotterAug 25, 2025
  If the fans in your SCHÖLLY FIBEROPTIC Medical Equipment are not working, it indicates a malfunction. Send the light source in for repair.
Z
Zachary GambleAug 29, 2025
Why SCHÖLLY FIBEROPTIC LED Light Source auto light control is not possible?
- W
  Wayne MontgomeryAug 29, 2025
  Auto light control may not be possible with your SCHÖLLY FIBEROPTIC Medical Equipment if the camera being used does not support auto light control. Use a compatible camera model.
S
Samantha BradleySep 4, 2025
Why the light guide cannot be coupled with SCHÖLLY FIBEROPTIC LED Light Source Medical Equipment?
- M
  Michael AllenSep 4, 2025
  If the light guide cannot be coupled with your SCHÖLLY FIBEROPTIC Medical Equipment, it may be due to a missing adapter on the light guide connection. Screw on the adapter.
K
Kevin GonzalezSep 10, 2025
What to do if SCHÖLLY FIBEROPTIC Medical Equipment light does not switch off?
- S
  Susan HuntSep 12, 2025
  If the light on your SCHÖLLY FIBEROPTIC Medical Equipment does not switch off even after removing the light guide: * Ensure the light guide was locked by rotating the multi-light-guide adapter. * Verify you are using a compatible light guide; an incompatible one can cause this issue.

SCHÖLLY FIBEROPTIC LED Light Source Specifications

General

Brand	SCHÖLLY FIBEROPTIC
Model	LED Light Source
Category	Medical Equipment
Language	English

SCHÖLLY FIBEROPTIC LED Light Source - User Manual

Table of Contents

Questions and Answers

SCHÖLLY FIBEROPTIC LED Light Source Specifications