6 Maintenance and Repair
6.4 Changing of the Fuse
6.4 Changing of the Fuse
Changing the fuse
Proceed as follows:
1. Switch OFF the device at the main switch on the rear and pull out the power
cord from the rear of the device to disconnect the power.
NOTICE! Pulling the power cable will damage it. Disconnect the power at the
plug.
2. Release the fuse holder with a screwdriver.
Figure 6-1: Releasing the fuse holder with a screwdriver.
3. Pull out the fuse holder carefully, without tilting.
WARNING! Unsuitable electrical fuse. Risk of fire and short circuit. Use the
specified fuse only and never bypass the fuse.
4. Replace the faulty fuse.
5. Carefully slide the fuse holder back in until it clicks into place.
This concludes the fuse replacement.
Instructions For Use | 13 - Mar - 2020 | Version: B Page 70 of 78
To Next Page