ProLab 2000 Operation
35
ba75577e03 11/2009
4.4.4 Automatic Stability control
The automatic Stability control function continuously checks the
stability of the measurement signal. The stability has a considerable
impact on the reproducibility of measured values.
You can activate or switch off the automatic Stability control function
(see page 34).
The automatic Stability control function is carried out:
z as soon as the measured value is outside the allowed stability range
z when you switch over between the measured parameters with
<MODE>.
In this case, the measured parameter flashes on the display.
System / Interface /
Output format
ASCII
CSV
Output format for data
transmission
For details, see page 89
System / Interface /
Output header
The header is output to the
interface in csv format.
System /Clock
function
Time
Date
Date format
Settings of time and date.
For details, see page 27
System /Service
information
Meter information:
Series number and software
version
System /Reset - Resets the system settings to
the default values.
For details, see page 94
Menu item Setting Description
To Next Page
Loading...