ProLab 2000 Operation
87
ba75577e03 11/2009
Quitting the display To quit the display of stored measuring datasets, you have the
following options:
z Switch directly to the measured value display with <MODE>.
z Quit the display and move to the next higher menu level with <ESC>
or <MENU/OK>.
4.9.4 Erasing the data storage
How to erase the measured value storage is described on page 84.
4.9.5 Displaying and downloading calibration records
You can display the calibration data
z of one selected sensor, or
z of all sensors connected
and then download them to the interface.
Displaying the
calibration record of a
selected sensor
The calibration record of the last calibration can be found under the
Calibration / Calibration record menu item in the respective measuring
menu. To open it, activate the relevant measuring window in the
measured value display and press <MENU/OK>.
Displaying the
calibration records of all
sensors connected
The calibration records of the last calibration can be found under the
Data storage / Calibration data storage menu item in the system menu.
In the measured value display, open the system menu with <MENU/
OK
_>.
With the <CAL
_> key you can go directly to the Calibration data
storage menu.
To Next Page
Loading...