EasyManuals Logo

SCHUNK PWG-S 40 Translation Of The Original Manual

SCHUNK PWG-S 40
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #24 background imageLoading...
Page #24 background image
Maintenance and Care
24 02.02|PWG-S 40 - 80|en
Servicing and assembling the module
Position of the position numbers ( 10, Page 26)
WARNING
Risk of injury due to spring forces!
The lid is under spring tension.
Carefully disassemble the module.
Clean all parts thoroughly and check for damage and wear.
Treat all greased areas with lubricant.
Link Schmierstoffe/Schmierstellen
Oil or grease bare external steel parts.
Replace all wear parts / seals.
Position of the wearing parts ( 10
, Page 26)
Seal kit ( 11
, Page 27)
Assembly takes place in the opposite order to disassembly. Ob-
serve the following:
An assembly bolt is required for the assembly of the PGW-S 80
( 9.5.1
, Page 25).
Unless otherwise specified, secure all screws and nuts with Loc-
tite no. 243 and tighten with the appropriate tightening torque.
9.5
Maintenance
Assembly
www.comoso.com

Other manuals for SCHUNK PWG-S 40

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the SCHUNK PWG-S 40 and is the answer not in the manual?

SCHUNK PWG-S 40 Specifications

General IconGeneral
BrandSCHUNK
ModelPWG-S 40
CategoryPower Tool
LanguageEnglish

Related product manuals