02.02|PWG-S 40 - 80|en
7
Basic safety notes
Intended use
The product was designed to grip and to temporarily and securely
hold workpieces and objects.
The product is intended for installation in a machine/system. The
requirements of the applicable guidelines must be observed and
complied with.
The product may be used only in the context of its defined applica-
tion parameters ( 6
, Page 12).
The product is designed for industrial use.
To use this unit as intended, it is also essential to observe the
technical data and installation and operation notes in this manual
and to comply with the maintenance intervals.
Not intended use
Use which is not specified as an intended use is for instance when
the product is for example used as a pressing tool, stamping tool,
lifting tool, guide for tools, cutting tool, tensioning mean, boring
tool.
Environmental and operating conditions
• Make sure that the product and the top jaws are a sufficient
size for the application.
• Make sure that the product has a sufficient size for the applica-
tion.
• Observe Maintenance and lubrication intervals ( 9.2
, Pa-
ge 21).
• Make sure that the environment is free from splash water and
vapors as well as from abrasion or processing dust. Exceptions
are products that are designed especially for contaminated en-
vironments.
2
2.1
2.2
2.3
To Next Page
Loading...
Need help?
General
