6
Wire
Storage
4. Put the Battery Pack back to the slot where the Battery Pack
Cover is originally positioned.
Make sure the EXO-COM Controller, the Battery Pack Assembly,
Mic/Speaker and its wire are all properly set.
To find detailed information about using the EXO-COM Controller,
refer to the EXO-COM Quick Start Guide, or User’s Manual by
scanning QR code in the EXO-COM Quick Start Guide.
4
Put the wires into the pocket of left cheek pad.
It will help you ride comfortably.
NOTE: WHEN YOU RE-INSTALL THE LINER, CHECK IF
ANY PART OF EXO-COM WIRE IS ON THE LINER SNAP
HOLE. IT MAY CAUSE WIRE DISCONNECTION IF THE
SNAP STRONGLY PUSHES THE WIRE.
To Next Page
Loading...