Scott Safety Simple - Cabinet Panel Removal: Finger Screw Type; Access Panel Removal with Finger Screws

3 - Starting and Operating
Stationary Air Compressor System Operating Instructions
17
FINGER SCREWS
Finger Screws
Only the access panel over the purication lters is
removable on this version. There are eleven (11) nger
screws that hold the panel in place: four (4) on each
side and three (3) across the bottom. There are three
(3) non-removable screws across the top that hold the
internal locator bar.
1. Use ngers or a at-blade screwdriver to loosen the
eleven (11) nger screws on the access panel.
2. Tilt the bottom of the panel out slightly away from
the enclosure.
3. Pull the panel straight out to remove. Place the
access panel in a safe place while performing the
pre-operation checks.
ALWAYS replace the panel prior to starting the
compressor. To replace the enclosure panel:
1. Tilting the panel at an angle, position the internal
locator bar in the top of the opening.
2. Make sure the nger screws all align with their
mating holes in the xed panel.
3. Secure the eleven (11) nger screws. If necessary,
using a at-blade screwdriver to snug the screws.
DO NOT OVER TIGHTEN.