EasyManua.ls Logo

Scott Safety Simple - Introduction to Stationary Air Compressor Systems; Manual Scope and System Overview; Critical Safety: Installation and Operation

Scott Safety Simple
48 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5
Stationary Air Compressor System Operating Instructions
1 - Introduction
Congratulations on your purchase of a SCOTT Safety
Stationary Air Compressor System. SCOTT Safety pro-
vides a full line of breathing air system components and
related accessories for the safe production and storage
of compressed breathing air.
This manual provides instructions for the operation of the
Stationary Air compressor including the control panel,
compressed air storage systems, and some optional
accessories. Use of the charging station is covered in a
separate user instruction.
These instructions are categorized by component, since
congurations of breathing air systems will vary depend-
ing on selected options. Operators of these units must
become familiar with their particular system congura-
tion and refer to the proper instructions as covered in
this manual.
This air compressor and equipment are intended for
charging breathing air cylinders for use in respirators or
self-contained breathing apparatus (SCBA). The com-
pressor and purication system are designed to purify air
to meet or exceed recognized air standards as specied
by the Compressed Gas Association (CGA G-7.1) and
National Fire Protection Association (NFPA 1989).
Before use, this equipment must be properly installed
and inspected by a SCOTT Safety trained and
certied technician. Do not operate if the equipment
has not been prepared by a SCOTT authorized
service technician. Use of this equipment without
proper set up may result in serious personal injury,
death, or permanent equipment damage.
Proper installation of the Stationary Air Compressor Sys-
tem must be performed in accordance with SCOTT Safety
requirements, for optimum performance and adequate
warranty coverage. Maintenance of the system beyond
the instructions provided herein must be performed by
a SCOTT trained and certied technician.
For additional information regarding the design, opera-
tion, or service of the Stationary Air Compressor System,
contact SCOTT Safety at 1-800-247-7257.

Table of Contents

Related product manuals