SCP SCIENCE DigiPREP - Screens; Banner Screen; Menu Screen; Utilities Screen

KeyPad
Version 1.0
SCP SCIENCE
13
SCREENS
BANNER SCREEN
The banner screen is displayed during power-up,
it will change to the menu screen after a short delay.
MENU SCREEN
From the menu screen, you can select either the
'OPERATION' screen or the 'UTILITIES' screen. From
the 'UTILITIES' screen you can change the language,
select the block model, and calibrate the system.
The 'OPERATION' screen lets you set the block tem-
perature and target time.
UTILITIES SCREEN
There are three options: LANGUAGE, SYSTEM,
and CALIBRATE.
The calibration screen will be
explained in the last point of this
section.
LANGUAGE SCREEN
The language screen lets you select the display
language.
Be careful not to select an unfamiliar
language as it may be diffi cult to
change back.
En- English
FR- French
DE- German
IT - Italian
ES- Spanish
NL - Dutch
JP- Japanese (romanized)
Next, select which DigiPREP system you are
using. Your selection determines the correct set
of PID values that the controller will use to ensure
precise control of the temperature of the block:
SYSTEM SCREEN
JR- DigiPREP JR. (24 position- ambient to 180
o
C)
MS- DigiPREP MS (48 position- ambient to 180
o
C)
LS- DigiPREPLS 72 position- ambient to 180
o
C)
HP- DigiPREP HP (hot plate- ambient to 180
o
C)
HT- DigiPREP HT (all HT models- ambient to
450
o
C)
The system will perform properly
only if the correct block is selected.
The selection you make will be stored in the
memory of the controller, so there is no need to visit
this screen every time you use the system.
LANGUAGE
EN FR DE IT ES NL >
LANGUAGE
<JP
SYSTEM
JR MS LS HP HT
SCP SCIENCE
DigiPREP KeyPad X.X
MENU
OPERATION UTILITIES
NOTE
UTILITIES
LANGUAGE SYSTEM
UTILITIES
< CALIBRATE
NOTE
NOTE