KeyPad
Version 1.0
SCP SCIENCE
51
ASSEMBLY
Assemble the DigiPREP HT system following the step listed below.
Insert the aluminum ‘U’ support into the 2 square
holes found in the top white ring, with thread holes facing
towards back
Insert and tighten two thumb screws through the
skin, and into the thread holes of the aluminum ‘U’
support.
Insert the right and left rack support panels. The short
90 degree bend goes toward the back of the system.
The cut outs should be placed facing up as shown in
the picture. Use 2 thumb screws to hold each of the
panels in place.
Set the block proportion of the DigiPREP HT with
the back sitting towards the front edge of a lab bench.
To Next Page
Loading...
