Elite Snack Vendor in that it has a Threaded Stud that screws into the Cagenut. To unlock the Front Door, insert key and turn
clockwise ¼ turn. When unlocked the "T" of the Lock will pop out from the vendor. Turn the Lock counter-clockwise until the Front
Door opens. To lock, push Front Door closed and turn Lock clockwise until the Gasket is firmly engaged. Note: Do not over tight-
en, as you could damage the Lock and Gasket.
ELECTRICAL
CONNECTION
The Elite Beverage Vendor requires one 120 VAC grounded outlet for each vendor(s).
Elite Beverage Vendor 120 Volts 4 Amps
TEMPERATURE CHECK
Once your vendor is unboxed you will need to plug in your vendor and allow the vendor to come to operating temperature. We
recommend that you perform this check prior to mounting the vendor to the Elite Snack Combo. It will take about 24hrs for the
vendor to reach operating temperature of 38º- 45º. Temperature fluctuation is normal, and will depend upon your local climate.
Note: Never lay your vendor on its side. To adjust the temperature, turn the Adjustment Slot Counter (1/8" at a time) clockwise
to a colder setting.
Elite Beverage Vendor
HFBV
Wiring Harness Plug
Front Door
Display Windows (5)
Lock
Product Door
(Interior view with
Front Door open)
Serpentine Product Chutes (5)
Display Panel (back)
Driver
Motors (5)
Product Door (back)
Pre-Cool Area
Vend Area
Lock
Cagenut
Section 3
ELITE BEVERAGE VENDOR
To Next Page
Loading...
