Seaga JDL-2 COMBO - Specifications and Cautions; Specifications; Cautions

4JDL V1.0 8 2022
SPECIFICATIONS
The vending machine is comprised of two(2) units - Snack Unit (JDLS) and Beverage Unit (JDLD). Installaon
and setup of these units is explained in the next secons of this manual.
Machine Descripon Snack Unit Beverage Unit
Model Number JDL2S
(115VAC)
JDL2S
(230VAC)
JDL2B
(115VAC)
JDL2B
(230VAC)
Height (in) 28.5” (72.4 cm) 28.5” (72.4 cm) 41.6” (105.7 cm) 41.6” (105.7 cm)
Width (in) 30.2” (76.7 cm) 30.2” (76.7 cm) 30.2” (76.7 cm) 30.2” (76.7 cm)
Depth (in) 28.6” (73 cm) 28.6” (73 cm) 28.6” (73 cm) 28.6” (73 cm)
Volts (V) 115 V 230 V 115 V 230 V
Frequency (Hz) 60 Hz 50 Hz 60 Hz 50 Hz
Was (W) 46 W 49 W 295 W 290 W
Current (A)* 0.4 A 0.22 A 3.6 A 1.87 A
Refrigerant Type NA NA R290 R134a
Refrigerant Charge NA NA 45 grams/1.59 oz 200 grams/7.05 oz
* - Current draw varies depending on Operang Condions and Load and are subject to change.
The vending machine is designed for use in indoor condions only. The recommended operang
environment is 75° F and 40% RH.
CAUTIONS
Your vender is intended for indoor use only.
Excessive heat, cold or humidity levels will void your warranty; install only in climate
controlled, indoor environments. For indoor machines the temperature range must be no
higher than 32°C/90°F and no lower than 10°C/50°F with a relave humidity (Rh) level of no
greater than 40%.
Your vender must be set on a level, well-supported locaon.
Always remove products before transporng it.
CAUTION!
It is important that this machine is hooked up to the proper voltage. Verify the voltage before
connecng the machine to a wall outlet.
CAUTION!
Dierent countries may have dierent power arrangements. Ensure that the machine is
properly grounded before operang.