If you turn on the scan tool and perform the I/M Readiness test but
the LED lamps are not working, there may be several possible causes,
including bad connection and ignition off. In this case, follow these
steps to check the scan tool.
Make sure the cable is connected to the DLC securely.
Verify the ignition key is in the KOER position.
Run the LED Test in the System Setup menu. (see 3.8 System
Setup). If the scan tool did not pass this test, there is a problem
with the LED lamp. Please contact Sealey Power Products or your
local selling agent.
To Next Page
Loading...
