If Manual Trigger is selected, following screen shows:
(Figure 5.24)
If DTC Trigger is selected, following screen shows: (Figure
5.25)
7) Wait for DTC to trigger recording or press OK to start recording.
(Figure 5.26)
8) The scan tool keep recording PID data until user presses ESC
button, the selected memory location is full, or it completes
recording. A message prompting to playback data shows on the
screen. (Figure 5.27)
If you wish to playback recorded data, press the OK button; if
you do not wish to playback, press the ESC button, or use the
LEFT/RIGHT button to select NO and press the OK button
to return to Record Data menu.
Playback Data
The Playback Data function allows viewing of previously stored
PID data.
1) To playback recorded data, use the UP/DOWN scroll button to
select Playback Data from Live Data menu and press the OK
button. (Figure 5.12)
You are also allowed to playback recorded data immediately
after recording.
2) Use the UP/DOWN button to select the memory location
marked with an asterisk (*) icon.
To Next Page
Loading...
