2) After the erase procedure is performed,the status of most monitors
will be changed. Leave the scan tool connected to the vehicle,
and select Ready Test from Main Screen.
3) Keep on driving the car until the scan tool notifies you with
coloured LEDs and audible tone that the drive cycle has been
completed and the vehicle is ready, eliminating drive cycle
guesswork and confirming readiness status.
4) If the GREEN LED lights and two long beeps are heard, the
vehicle is ready and the repair work is confirmed.
5) If the RED LED lights, the vehicle is not ready and the repair
work is unsuccessful.
As pre-check diagnostic tool
Prior to having a vehicle inspected for compliance to an
emissions test, this function can be to check the readiness
status .
1) While the scan tool connected to the vehicle, select Ready Test
from Main Screen. Drive the car till the scan tool notifies with
coloured LEDs and audible tone if the vehicle is ready to conduct
emissions test.
2) If the GREEN LED lights and two long beeps are heard, the
vehicle is ready and can be tested.
3) If the RED LED lights, the vehicle is not ready and must be
repaired before an emissions test can be performed.
IMPORTANT: If you are driving the vehicle to perform a drive
cycle ALONE, please set the Status Beep On (see 3.8 System Setup).
By listening to the beep, you will learn when the monitors have run
and completed the diagnostic testing. NEVER try to drive and
operate the scan tool at the same time!
To Next Page
Loading...
