Operation • 41
Tare off additional
weight (TARE)
You can use the TARE function to prevent the weighing
result from being affected by an additional weight (e.g.
a towel or pad on the weighing surface).
ATTENTION!
Incorrect measurement with force shunt
If an additional weight (e.g. large towel) is in
contact with the surface on which the scales
are standing, the weight will not be measured
correctly.
− Make sure that any additional weight is only
placed on the weighing surface of the scales.
1. Place the additional weight on the scales.
2. Hold down the arrow key (hold/tare) until "NET"
appears in the display.
3. Wait until the display stops flashing and is replaced
by 0.000.
4. Place the baby on the scales.
5. Read off the measured result.
The additional weight has been automatically
deducted.
6. To disable the TARE function, press the arrow key
(hold/tare) until "NET" no longer appears in the
display or switch off the scales.
NOTE:
The maximum weight that can be displayed is
reduced by the weight of the objects already
placed on the scales.
Continuous display of
measured
result (HOLD)
If you activate the HOLD function, the weighing value
will continue to be displayed after the baby has been
removed. This allows you to attend to the child before
noting down the weight.
1. Place the baby on the scales.
2. Briefly press the arrow key (hold/tare).
The display will flash until a stable weight is meas-
ured. The weighing value will then be displayed
continuously. The symbol (non-calibratable func-
tion) and the message "HOLD" will be displayed.
3. To disable the HOLD function, briefly press the ar-
row key (hold/tare).
The symbol and the message "HOLD" will no
longer be displayed.
To Next Page
Loading...
