Seca 374 - Set up Wireless Group (Lrn)

50 •
2. Select the menu item "SYS" in the "rf" submenu.
3. Confirm the selection.
4. Select "on".
5. Confirm the selection.
You will leave the menu automatically.
Set up wireless group
(Lrn)
To set up a wireless group proceed as follows:
1. Switch the device on.
2. Call up the menu.
3. Select the item "rF" in the menu.
4. Confirm the selection.
5. Select the menu item "lrn" (learn) in the "rf" sub-
menu.
6. Confirm the selection.
The wireless group currently selected (here: wire-
less group 0 "ID 0") is displayed.
If the wireless group "0" already exists and you wish
to set up another wireless group with this device,
use the arrow key to select another ID (here: wire-
less group 1 "ID 1").
7. Confirm your selection for the wireless group.
The device will suggest a channel number for chan-
nel 1 (here C1 "0").
You can either accept the channel number sug-
gested or select another channel number using the
arrow key.
8. Confirm your selection for channel 1.
The device will suggest a channel number for chan-
nel 2 (here C2 "30").
You can either accept the channel number sug-
gested or select another channel number using the
arrow key.
NOTE:
Two-digit channel numbers are displayed with-
out a space. The display "C230" means: chan-
nel "2", channel number "30".