Seca 374 - Select Print Option (Aprt); Set Time (Time)

52 •
NOTE:
If you are using a wireless printer, ensure that
“off” is not set as a print option (see "Select
print option (APrt)" on page 52).
1. Switch the device on.
2. Select the menu item "ASend" in the "rf" submenu
and confirm your selection.
3. Select "on" and confirm your selection.
You will leave the menu automatically.
Select print
option (APrt)
You can configure the device so that measured results
are automatically printed out by a wireless printer
logged into the wireless group.
NOTE:
This function is only available if the "learn" func-
tion has been used to integrate a seca wireless
printer in the wireless group.
1. Switch the device on.
2. Select the menu item "APrt" in the "rf" submenu
and confirm your selection.
3. Make the appropriate selection for your combina-
tion of devices:
– HI: Measured results from length measuring
devices (not functional with this model)
– MA: Measured results from scales
– HI_MA: Measured results from length meas-
uring devices and scales (not functional with
this model)
– off: No automatic printout, printout only if En-
ter key is held down during weighing.
4. Confirm your selection.
You will leave the menu automatically.
Set time (Time) You can configure the system so that the wireless
printer automatically adds the date and time to the
measured results. To do so, you have to set the date
and time once on the device and transmit this to the
wireless printer's internal clock.
NOTE:
This function is only available if the "learn" func-
tion has been used to integrate a seca wireless
printer in the wireless group.
1. Switch the device on.