Seca 374 - Transmit Measured Results to a Radio Receiver; Switch off Scales

42 •
NOTE:
If the Autohold function is activated, continuous
display of the weighing value will take place
automatically. see "Activate Autohold function
(Ahold)" on page 45.
Transmit measured
results to a radio
receiver
If the scales are integrated in a seca 360° wireless net-
work, you can transmit the measured results to
receive-ready equipment (wireless printer, PC with
wireless USB module) at the touch of a button.
♦ Press the Enter key (send/print).
– Press key briefly: Send measured results to
all receive-ready equipment
– Hold down: Print out measured result using
wireless printer
Switch off scales ♦ Press the Start key.
NOTE:
When in battery mode, the scales will switch off
automatically after a short period if no load is
placed on them.
send
print