Seca 374 - (Ahold)

Operation • 45
English
14. Select the memory location where you stored the
baby's initial weight (here: 2).
Arrows can be seen flashing in the display.
15. Confirm your selection.
The weight difference, i.e. the quantity of food con-
sumed, is displayed.
16. To disable this function, select the item BMIF in the
menu again.
17. Confirm your selection.
The function is disabled.
You will leave the menu automatically.
Activate Autohold
function (Ahold)
If you activate the Autohold function, the measured
result for each weighing operation will continue to be
displayed after the baby has been removed. This
means you no longer have to manually activate the
Hold function for every weighing operation.
NOTE:
With certain models this function is already acti-
vated at the factory. If required, you can disable
this function.
1. Select the item "Ahold" in the menu.
2. Confirm the selection.
The current selection is displayed.
3. Select the setting you require:
–On
–Off
4. Confirm your selection.
You will leave the menu automatically.
Activate acoustic
signals (BEEP)
You can select whether an acoustic signal is to be
emitted whenever a key is pressed or a stable weighing
value has been attained. The latter is relevant for the
Hold/Autohold function.
NOTE:
The function "Acoustic signal with stable weigh-
ing value" is activated at the factory. If required,
you can disable this function.
1. Select the item "BEEP" in the menu.
2. Confirm the selection.