SECOP 101N08 Series User Manual

3
Operating
Instructions
The Secop BD compressors with 101N08xx Series 12-24V DC are designed for use in:
• Comfort cooling in parking anti-idle applications
• Spot and comfort cooling in buses, golf carts, smaller boats, forklifts, campers etc
• Cooling of switchboards and batteries in radio stations for cellular phones
• Mobile refrigeration applications
• Air cargo cooling
• Mobile cooling boxes of volume up to 1000L
• Mobile refrigeration applications
For R134a compressor variants:
One application module can control either single or twin compressor configurations.
The cooling capacity of the single compressor configuration is approx. 900 Watt @ Pe/Pc
~+15/+55°C
The cooling capacity of the twin compressor configuration is approx. 1800 Watt @ Pe/Pc
~+15/+55°C
The system is able to operate in ambient temperatures up to +55 ºC.
The operating conditions are High Back Pressure (HBP).
For R404A/R507 compressor variants:
The cooling capacity of the compressor is approx. 380 Watt @ Pe/Pc ~-5/+55°C
The system is able to operate in ambient temperatures up to +55 ºC.
The operating conditions are Low Back Pressure (LBP).
The main functions of the controllers are:
• Operation using either 12 V DC or 24 V DC
• Simultaneous and independent control of two compressors in twin configuration
• ECO function to optimize compressor speed for minimum power consumption
• Detailed error log
• Event log
• Motor / Compressor speed control
• Thermostat control (ON / OFF or electronic via NTC temperature sensor)
• Condenser fan control
• Evaporator fan control
• Communication interface
• Monitoring function
• Battery protection functions
• Main Switch
• Log of specific parameters
• Optimization of specific parameters via PC software before commencing mass production
The controller can be accessed using either
• The Secop software tool Tool4Cool
®
LabEdition, or
• A custom interface. Please contact Secop for further information regarding custom interfaces
1.
INTRODUCTION
1.1
Applications
1.2
Capability
1.3
Functions
1.4
Programming
Interface

SECOP 101N08 Series Specifications

General

Brand	SECOP
Model	101N08 Series
Category	Controller
Language	English