151
Using the Configurator
Date and Time
Page Inhibit This timer is started by the first active alarm. Paging is
inhibited while this timer is running. As per UL 864 and UL
2572 only a setting of 0 is permissible.
Choose from 10-120 seconds.
Powerfail Send Delay If the only trouble is an AC power failure, this is the
amount of time after the power failure that the system
delays transmission of status to the monitoring station.
The default is 3 hours. The maximum time is 18 hours.
See section 19.11 on page 163.
Proving Circuit Delay This timer is used for fan dampers. If the monitor inputs do
not activate within the specified time (indicating that the
fan has not started running, or the damper has not moved
to its commanded position), then a trouble will be reported
and LEDs associated with the fan damper switch will
flash.
Choose from 5-90 seconds.
Auto Resound This timer specifies the time, in minutes, after which the
signals will resound if an alarm remains un-
acknowledged. The default is 10 minutes. See section
19.45 on page 206.
Choose from 5-12 minutes.
Daily clock adjustment The number of seconds (positive or negative) by which
the system adjusts the panel's clock every 24 hours. The
adjustment happens at 01:55 every day.
Enable Daylight Saving Enables automatic change to and from daylight saving
time. You can specify when daylight saving time begins
and ends.
Enable Auto After Hours Specifies when the system automatically goes into After
Hours mode. If After Hours mode is enabled, then you can
change the detector sensitivity for the times designated as
After Hours (because there will be fewer people in the
facility, the sensitivity might need to be higher).
Holidays A list of the defined holidays, when the system will go into
After Hours mode.
Reprogram Holiday Trouble Select this check box to put the system into trouble when
there are no future holidays programmed. Specify the
date after which there are no programmed holidays. The
system will be in trouble until more holidays are added, or
until the check box is unselected.
To Next Page
Loading...
Need help?
General
