161
Using the Configurator
• MONITOR: 3
To enter a passcode on the main display
1. Press the queue buttons corresponding to the numbers. For example, to enter the
passcode 2222, press the TROUBLE QUEUE button 4 times.
2. Press the ENTER button.
19.8.2 Access Levels
Specify the level of access for various panel actions.
• 0 means that the panel operator does not need to enter a passcode.
• 1 means the operator must enter the code specified for Level 1, in the Passcodes
section.
• 2 means the operator must enter the code specified for Level 2, in the Passcodes
section.
• 3 means the operator must enter the code specified for Level 3, in the Passcodes
section.
The permissions given to each passcode apply to the levels under it. For example, an operator
who has the Level 3 passcode has access to the actions assigned to Levels 2 and 1.
19.9 Remote CPU
This section appears on remote annunciators only.
Figure 110 Remote CPU
Tag Type a tag for the annunciator. The tag appears in the Job
Tree.
CPU Address Select the remote CPU number for the remote
annunciator.
To Next Page
Loading...
Need help?
General
