Secutron MMX-2003-12NDS Application Guide

214
List of Procedures
To connect the computer to the Fire Alarm Control Panel ................................................................17
To send a job ....................................................................................................................................18
To get the current active job from the Fire Alarm Control Panel .......................................................19
To export the job as a database file or an XML file ..........................................................................20
To manage jobs on the panel ...........................................................................................................20
To change the active job using the Fire Alarm Control Panel ...........................................................21
To change the active job using the Configurator ..............................................................................22
To delete a job ..................................................................................................................................22
To get configuration information from the Configurator ....................................................................23
To get configuration information from the FACP ..............................................................................24
To get information about the CodeMeter Key ...................................................................................24
To perform a network restart of the system ......................................................................................26
To perform a network restart of a single CPU ..................................................................................26
To perform a hard restart ..................................................................................................................26
To upgrade the firmware on a system ..............................................................................................29
To open the Advanced Logic Editor ..................................................................................................36
To apply a Device Status ..................................................................................................................38
To add an input to the equation ........................................................................................................40
To add an operator to the equation ..................................................................................................40
To add a system defined value .........................................................................................................40
To create a zone ...............................................................................................................................41
To correlate the zone with an input ...................................................................................................41
To correlate the zone with an output ................................................................................................41
To create an equation with OR .........................................................................................................42
To create an equation with NOT .......................................................................................................42
To create an equation with ANY .......................................................................................................43
To create an equation with EQU .......................................................................................................44
To assign the nodes to the groups ...................................................................................................46
To assign switches to the groups .....................................................................................................46
To assign zones to the nodes ...........................................................................................................47
To use advanced logic to communicate between groups .................................................................47
To create a zone and inputs .............................................................................................................48
To add the equation ..........................................................................................................................48
To correlate the zone with an output ................................................................................................50
To start a one man walk test .............................................................................................................53
To stop the walk test .........................................................................................................................54
To browse the devices in the walk test list ........................................................................................55
To view the device information for the last selected device ..............................................................55
To start an assisted walk test ...........................................................................................................56
To browse the devices in the walk test list ........................................................................................57
To view the device information for the last selected device ..............................................................57
To view the results of the last walk test ............................................................................................58
To create a walk test area ................................................................................................................60
To create a custom timer ......................................................................................................
............62
To correlate the timer with an input ..................................................................................................63
To correlate a zone with the timer ....................................................................................................63

Secutron MMX-2003-12NDS Specifications

General

Brand	Secutron
Model	MMX-2003-12NDS
Category	Control Panel
Language	English