Using a power supply which is not equipped with the earth leakage breaker can cause a fire
when
earth leakage occurs.
• Be sure to use fuses which meet the specified
rating. (Only for the machines which use fuses.)
Using fuses exceeding the specified rating can cause a fire and an electric
• Specification changes (removal of equipment, conversion and addition)
not designated by SEGA are not allowed.
The parts of the product include warning labels for safety, covers for personal protection, etc. It
is very hazardous to operate the product by removing parts and/or modifying the circuits. Should
doors, lids and protective parts be damaged or lost, refrain from operating the product, and
contact where the product was purchased from or the office herein stated.
SEGA shall not be held responsible for any accidents, compensation for damage to a third party,
resulting from the specifications not designated by SEGA.
• Ensure that the product meets the requirements of appropriate
electrical specifications.
Before installing the product, check for electrical specifications. SEGA products have a
nameplate on which electrical specifications are described. Ensure that the product is compatible
with the power supply voltage and frequency requirements of the location. Using any electrical
specifications different from the designated specifications can cause a fire and an electric shock.
• Install and operate the product in places where appropriate lighting is
available, allowing warning labels to be clearly read.
To ensure safety for the customers, labels and printed instructions describing potentially
hazardous situations are applied to places where accidents can be caused. Ensure that where
the product is operated has sufficient lighting allowing the warnings to be read. If any label is
peeled
off, apply it again immediately. Please place an order with where the product was purchased
from or the office herein stated.
• When handling the monitor, be very
careful. (Applies only to products with
monitors.)
Some of the monitor parts are subject to high tension voltage. Even after turning off the power,
some portions are still subject to high tension voltage sometimes. Monitor repair and
replacement should be performed only by those technical personnel who have knowledge of
electricity and
technical expertise.
• Be sure to adjust the monitor properly.
(Applies only to products with
monitors.)
Do not operate the product leaving on-screen flickering or blurring as it is. Using the product
with the monitor not properly adjusted may cause dizziness or a headache to an operator, a
player, or the customers.
• When transporting or reselling this product, be sure to attach this manual
to the product.
* In the case where commercially available monitors and printers are used in this product, only
the contents relating to this product are explained herein. Some commercially available
equipment has functions and reactions not stated in this manual. Read this manual together with
the specific instruction manual of such equipment.
* Descriptions herein contained may be subject to improvement changes without notice.
* The contents described herein are fully prepared with due care. However, should any question
arise or errors be found, please contact SEGA.
BEFORE USING THE PRODUCT, BE SURE TO READ THE FOLLOWING:
To Next Page