15. CLEANING & MAINTENANCE FOR COIN SELECTOR
15-1
Handling the Coin Jam
If the coin is not returned when the REJECT button is pressed, open the coin chute
gate and the selector gate, remove the jammed coin, and then put a normal coin in
and check to see whether the selector is workable
.
15-2 CLEANING & MAINTENANCE FOR COIN SELECTOR
IMPORTANT
● Remove and clean smears by using a wet soft cloth or diluted chemical
detergent, and then wipe it dry.
● Never apply machine oil to the Coin Selector.
●
After cleaning the Coin Selector, insert a regular coin in the normal working status
and ensure that the selector is under correctly function.
● The Coin Selector should be cleaned once every 3 months.
please follow the below procedure When cleaning the Coin Selector.
1
Turn off the machine power first, and then open the coin chute gate.
2
Remove the Coin Selector from the coin chute gate.
Open the gate and dust off by using a soft brush
(Small soft paint brush, etc.)
CLEANING THE COIN SELECTOR
(MECHANICAL)
Remove and clean smears by using a wet soft cloth or diluted chemical detergent and then
wipe it dry.
Remove the CRADLE. When removing the retaining ring (E ring), be very careful so
as not to bend the rotary shaft.
Remove stain from the rotary shaft and shaftreceiving portions
by wiping off with a soft cloth. etc.
After wiping off as per previous step, further apply a
dry cloth to completely dry the Coin Selector.
15. CLEANING & MAINTENANCE FOR COIN SELECTOR
To Next Page
Loading...
