8. PRECAUTIONS WHEN MOVING THE MACHINE
CASE 1: the operator should follow the below method to take apart the billboard lamp
and the two-side billboard plate. When moving over a long distance, or entering a narr
ow elevator (not smaller than 1630*1370*2600mm), and passing rough road.
1 Disassemble the right side billboard plate
2 Unplug the right lamp wire connector
3 Disassemble the left side billboard plate
Unscrew 3pcs of M4*25 cross flat
head screws with 3mm hexagonal
key,
Steady the side plate to prevent falling
down, and handle gently to avoid any
scratch on the organic plate.
Unscrew 3pcs of M4*25 cross
flat head screws with 3mm
hexagonal key
Steady the side plate to
prevent falling down, and
handle gently to avoid any
scratch on the organic plate.
8. PRECAUTIONS WHEN MOVING THE MACHINE
To Next Page
Loading...
